Test c and eq cycle results

I have a D8 flooded lead acid battery 1400CCA and 255Ah capacity. it is 6 years old on a boat with a 3 stage 12 amp charger which is on all the time when the boat is not in use.
battery is now very low in specific Gravity 1175 less than 40% capacity. it’s voltage 3 days after a full charge is .  this is far too high and we suspected sulfation to possibly be the cause of the higher voltage.(we read this somewhere)
we then overcharged it at 16 volts and it only drew 3 amps . After about 17 hours the SG had gone up to above 1200 about a 50% charge. a remarkable improvement.
my question to you all is why is the battery voltage still high on open circuit and why is there only 3 amps of charge at 16volts. should we continue to overcharge it ?

This versions will give correct answers for n less than 341550071728321 and then reverting to the probabilistic form of the first solution. By selecting predetermined values for the a values to use instead of random values, the results can be shown to be deterministically correct below certain thresholds.
For 341550071728321 and beyond, I have followed the pattern in choosing a from the set of prime numbers.
While this uses the best sets known in 1993, there are better sets known , and at most 7 are needed for 64-bit numbers.

Thank you so much for all your help! I just took the LEED NC exam this afternoon after studying for 1 month on my own, using just the reference guide, my own notes (I’m an obsessive-compulsive note taker), and your website – no classes, workshops or sample exams – and passed! I got a 184, which I am very happy with already. Was a bit nervous because I took no sample exams nor any background in building design or construction, but in the end all the hard work paid off! Thanks again for the terrific help. Such a great feeling! =)

Test c and eq cycle results

test c and eq cycle results


test c and eq cycle resultstest c and eq cycle resultstest c and eq cycle resultstest c and eq cycle resultstest c and eq cycle results